Electric pressure cooker lid and steam release handle

Check these first (Instant Pot's list)

CheckWhat to look forFix
Sealing ringMissing, cut, stretched, deformed, or covered in foodInstall, clean, or replace; reseat behind the wire rack
Lid closedLid not fully closedOpen, close again
Float valveStuck, dirty or with a worn silicone capRemove, clean, reinstall or replace; add liquid if scorching
LiquidNot enough thin, water-based liquidAdd liquid to the minimum for your size
Sealing ring rackBent, warped or off-centerContact customer support
Inner pot rimMisshapenContact customer support

Instant Pot's FAQ and its help page for steam leaking from the lid side and for a float valve that will not rise.

Step by step: troubleshoot a lid that will not seal

  1. Stop if steam keeps escaping

    Instant Pot says if steam leaks for more than 3 minutes, record a short video, turn the appliance off and unplug it.

  2. Check the ring

    Make sure it is installed around the metal wire rack under the lid and snug behind it. Replace a stretched or damaged ring.

  3. Clean the ring and float valve

    Remove food debris from the ring and clean the float valve and its silicone cap.

  4. Close the lid properly

    If the lid will not close, check the ring seating, press the float valve down gently with a long utensil, and if contents are hot set the steam release handle to Venting and lower the lid slowly (Instant Pot).

  5. Check the liquid

    Add thin, water-based liquid to the minimum for your size. Thick sauces need an extra cup of thin liquid.

  6. Run an initial test run

    Instant Pot's help page uses a test run to check heating and sealing after cleaning parts.

Minimum liquid by pot size

Pot sizeMinimum thin liquid
3 quart1 cup (250 mL)
6 quart1 1/2 cups (375 mL)
8 quart2 cups (500 mL)
10 quart2 1/2 cups (625 mL)

Instant Pot FAQ. Duo Crisp with Ultimate Lid: at least 2 cups. Thicker sauces need an extra cup of thin liquid.

Float valve that will not rise

Instant Pot's help page lists food debris on the float valve, too little liquid, a worn silicone cap and a lid-locking mechanism blocking the valve. Clean the valve, add 1 cup of liquid if the bottom is scorched, and replace a worn cap. If that fails, contact support.

Sealing ring replacement

Instant Pot says to replace the ring every 12 to 18 months or sooner, and to use only authorized rings. See the sealing rings guide for fit and the second-ring tip.

Safety rules

  • Never force the lid open after pressure cooking; release pressure fully first (Instant Pot).
  • Avoid recipes with more than 1/4 cup of oil or fat unless the recipe says otherwise (Instant Pot).
  • Follow the manual's max-fill line and valve checks.

Sources: Instant Pot: FAQ; Instant Pot help: steam leaks from the side of the lid; Instant Pot help: float valve unable to rise; Instant Pot help: difficulty closing the lid. Checked November 15, 2026.