Pick the method by how bad the burn is
| Burn | Method | Time | Source |
|---|---|---|---|
| Stuck-on food | Water, optional dish soap, simmer and scrape with a wooden or silicone spatula | 2 to 3 min simmer | Tramontina |
| Light burn | 1/2 in water + 1/4 cup white vinegar, boil 1 min, off the heat, add 2 tbsp baking soda, scrub | 1 min boil, then until fizzing slows | Tramontina |
| Deep burn | Same baking soda and vinegar mix, left to sit before scrubbing | 30 min | Tramontina |
| Heavy burn | Sprinkle baking soda, add water, boil, loosen with a wooden spoon | Until it lifts | All-Clad |
| Stubborn spots | Paste of Bar Keepers Friend or similar powder with a little water, rub in circles | A few minutes | All-Clad, Made In |
Amounts and times are what Tramontina, All-Clad and Made In publish; they differ in order and soak time, so start gentle and escalate.
Step by step: the gentle route
Scrape and soak
Let the pan cool, scrape loose food with a wooden or silicone spatula, and cover the burn with warm soapy water.
Simmer
Add about 1/2 inch of water and a squirt of dish soap and simmer 2 to 3 minutes, scraping as it loosens (Tramontina).
Add baking soda
For tougher cases add 1 tablespoon baking soda to the simmering water (Tramontina).
Scrub
Pour out the liquid and scrub with a soft sponge or nylon scraper.
Step by step: vinegar and baking soda for a heavier burn
Boil the vinegar
1/2 inch of water with 1/4 cup white vinegar, boiled for 1 minute.
Remove from the heat and add baking soda
2 tablespoons; it will foam, so use a large enough pan.
Wait
Let it fizz until it slows. For a deep burn, leave it 30 minutes (Tramontina).
Scrub and rinse
Use a nylon pan scraper or soft sponge, and rinse.
Using Bar Keepers Friend or a powdered cleaner
Tramontina says Bar Keepers Friend contains oxalic acid and should not sit on the pan for more than a minute: scrub, rinse and dry. Made In and All-Clad both name powdered cleaners for stubborn spots and rinse and dry immediately. Always follow the product's own label.
Rainbow or blue stains after overheating
Blue, gold or purple tint is a thin oxide layer, which Tramontina says is harmless, so the pan still works. To remove it, All-Clad says to wipe with white vinegar on a soft cloth; Tramontina uses equal parts vinegar and water, or about a tablespoon of Bar Keepers Friend for 3 minutes of scrubbing.
What to avoid
| Avoid | Reason | Source |
|---|---|---|
| Steel wool and steel scouring pads | Can scratch the finish permanently | All-Clad, Tramontina |
| Oven cleaner | Can damage the surface | All-Clad, Tramontina |
| Bleach or peroxide detergents | Listed to avoid | All-Clad |
| Salt added to cold water | White pitting spots: add salt after liquids boil | All-Clad |
How to prevent burning next time
- Preheat on low to moderate heat and add oil once the pan is hot (All-Clad).
- Use high heat only for boiling.
- Do not leave an empty pan on a hot burner.
- Let food release before turning it.
Sources: Tramontina: how to clean a stainless steel pan; Made In: how to clean a burnt stainless steel pan; All-Clad: care and use. Checked November 15, 2026.









